Python 323 Instrukcja Użytkownika Pobierz pdf (Strona 29)

Out of Range

Each time a command is performed the Responder LE will expect a

command conﬁrmation from the system. If a command conﬁrmation

is not received the

and transmit LED’s ﬂash and a long fault tone

plays as an alert.

No Remote Output

Occasionally when a command is performed the remote may not

generate a command conﬁrmation output or out of range output. This

indicates that the system received the command but it was an incom-

plete command (e.g. aux button pressed too short to activate the trunk

release) or it was an illegal message (e.g. the command was cor-

rupted due to local RF interference). These are temporary normal func-

tions of the system and remote, perform the command again within 10

seconds to return to normal operation.

Car Select

Car 2 must ﬁrst be turned on (See Remote Control Conﬁguration sec-

tion to turn on).

Press1. and hold the

button for 3 seconds. The remote ﬂashes

the transmit LED and beeps once or twice to indicate the selected

car is 1 or 2.

Release2. the

button, then press and release while the transmit

LED and beeps continue to perform car select. Once the car is

selected a command can be performed by pressing one of the

command buttons.

Note: The 1-way remote does not emit any indication beeps. The

transmit LED ﬂashes once or twice to indicate car one or car two.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 40 41

Brak uwag

Python 323 Instrukcja Użytkownika Strona 29